Verified and Tested 03/10/2015


This How-To will walk you through Configuring Windows Server 2012 R2 NIC Teaming to a Hyper-V Virtual Machine.

NIC Teaming is the name Microsoft gives for the process of combining multiple network interface controllers (NICs) together for speed, redundancy or both.


– A Windows Server 2012 R2 server with the Hyper-V role installed. If you’re interested in purchasing a server to run virtualized systems, please consider a dedicated server from Atlantic.Net.

– Minimum 2 NIC cards installed on your server.

Configuring Windows Server 2012 R2 NIC Teaming

Open the Server Manager. Right click on Hyper-V and select Configure NIC Teaming.

From server manager select hyper-v, proceed to right click your host, and select Configure Nic teaming.

Server Manager: Hyper-V

Locate the Task drop-down and select New Team. (Note: You will see the available NIC’s in the Adapters and Interfaces section).

Under teams Select New Team

NIC Teaming

For Team Name, type the name that want to set it up as. Check the NIC cards that you want to team. In the additional properties drop-down, change the Load Balancing Mode to Hyper-V Port. (Note: Teaming Mode should be defaulted to “Switch Independent” and Standby Adapter should be defaulted to “None(all adapters Active)”

Select the ethernet devices which you'd like to participate in the team.

New Team

You will get a red Fault alert on the status. Don’t worry it will come right up shortly and change to a green OK status.

Sample Team Status

Team Status

Team status

Team status

Click on the Team Interface tab. Right-Click on your Team Name and select Properties.

Team interface properties

Team interface properties

In the Properties, you should see the Description set to “Microsoft Network Adapter Multiplexor Driver”. In the VLAN membership, verify that the Default option is selected and click OK.

General Properties.

General Properties.

Go to Control Panel. Click Network and Internet. Click Network Connections and Right-Click on Your Team Name. Activate the “Microsoft Network Adapter Multiplexor Protocol (If it is not already checked).

Team Properties

Team Properties

Go back to the Server Manager. Right click on your server and select Hyper-V Manager.  Select the Virtual Switch Manager. Click Create Virtual Switch.


Create a Name for the Virtual Switch. Select External Network. Click on the Microsoft Network Adapter Multiplexor Driver. Verify that the “Enable virtual LAN identification for management operating system” is checked. Then Click Apply and OK.

Create a virtual switch from your New multiplexor team

Virtual Switch

Verify that NIC Teaming is working properly. Unplug one of the Network Cables on the NIC and notice that the server will remain with the network connection. Plug the Network Cable back and try it with the other Network Cable. (Note: You can also open up the command prompt while having one of the Network Cables disconnected and PING the Server. You will get a Reply from the Server with no problem).

Congratulations! You have just Configured Windows Server 2012 R2 NIC Teaming to a Hyper-V Virtual Machine. Thank you for following along in this How-To and check back with us for any new updates.